Increase fan speed. gain PWM controller

Discussions in English on using Fedora
#1

Hi,

I have been experiencing issues with ThermalD shutdown while using blender.
I get over temp shutdowns on CPU. I then have to wait 5 minuted before my laptop will boot.

I have since started monitoring the CPU/GPU and would like to increase the speed of the fan, while using blender, if possible, or just generally to stop this from happening.

The fans are controlled, i can hear the increase in speed, it is just not enough for the thermal loading while doing graphical processing.

I have looked at thermalD but i cant make any sense of it, I have installed lm_sensors, all sensors are coming in except for cpu_fan which registers 0rpm.

#2

I assume you already ran sensors-detect. You can run pwmconfig to see if you can configure manual control for the fan(s).

1 Like
#3

yes i can use pwmconfig to manually control the fans. however i have to set a flag in the chip to do so. I would like to leave it automatically controlled, but just increase the speed.

#4

If you have the newer (uefi) bios you may be able to go into the bios and set the fan speed profile there. I don’t recall which tab, but I had 4 options which as I recall were something like quiet, standard, extreme, & custom. The default on mine was quiet and I bumped it up to standard. The fans run at about 40% when idling and have bumped up to about 80% at 50% load and 55C cpu temp.